Eastwood 1/2inch Sheet Metal Dimple Male and Female Die Hole Flares Set

Description

Create flares in sheet metal up to 1/8" thick using this 1/2" Dimple Die.
Includes both Male and Female Dies
Form clean 45° flares in up to 1/8" thick steel
Made with high-strength Chrome Moly steel
Machined to close tolerances
Simply drill a 1/2" hole in the metal that you desire to dimple, then use a press to do the work. Made from heat-treated Chrome Moly steel, these dies are built to last.
Requires 1/2" hole
Flare Width 0.7"
Metal Flaring Capacity
Mild Steel: 1/8
Aluminum: 1/8
Stainless Steel: 3/32
Tools Required (not included)
A set of sharp, high-quality metal saws in sizes corresponding to those in the Die Set.
A 20 Ton Hydraulic Shop Press or equivalent.